Manufacturing Maintenance Specialist, TCC (MM21) (470303)  Technical Certificate of Credit

Pre/Co-requisite(s): Provisional Admission Introduces direct current (DC) concepts and applications. Topics include: electrical principles and laws; batteries; DC test equipment; series, parallel, and simple combination circuits; and laboratory procedures and safety practices.

This course provides instruction in the fundamentals of safely operating hydraulic, pneumatic, and pump and piping systems. Theory and practical application concepts are discussed. Topics include hydraulic system principles and components, pneumatic system principles and components, and the installation, maintenance, and troubleshooting of pump and piping systems.

Introduces electrical symbols and their use in construction blueprints, electrical schematics, and diagrams. Topics include: electrical symbols, component identification, print reading and scales and measurement.

Introduces the fundamental theories and applications of single-phase motors. Topics include: motor theory/operating principles, motor terminology, motor identification, NEMA standards, motor efficiencies, preventive maintenance, troubleshooting/failure analysis, and NEC requirements.

Introduces types of electric motor control, reduced voltage starting, and applications. Emphasis will be placed on motor types, controller types, and applications. Includes information on wye and delta motor connections; part wind, autotransformer; adjustable frequency drives and other applications; and oscilloscopes and their operation. Topics include: types of reduced voltage starting, reduced voltage motor connections, and adjustable frequency drive.

Introduces line and low voltage switching circuits, manual and automatic controls and devices, and circuits. Emphasis will be placed on switching circuits, manual and automatic controls and devices, line and low voltage switching circuits, and operation, application and ladder diagrams. Topics include: ladder and wire diagrams, switching circuits, manual controls and devices, automatic controls and devices, and application and operation of controllers and controls.

Introduces operational theory, systems terminology, PLC installations, and programming procedures for programmable logic controls. Emphasis is placed on pic programming, connections, installations, and start-up procedures. Topics include: PLC hardware and software, PLC functions and terminology, introductory numbering systems, PLC installation and set up, PLC programming basics, relay logic instructions, timers and counters, connecting field devices to I/O cards, and PLC safety procedures.

Introduces diagnostic techniques related to electrical malfunctions. Special attention is given to use of safety precautions during troubleshooting. Topics include: problem diagnosis, advanced schematics, and sequential troubleshooting procedures.

Provides instruction in industrial wiring applications of the National Electrical Code. Topics include: rigid/IMC conduit installation, EMT conduit installation, busways installation, cable tray/wireway installation, and equipment installation (600 volts or less).

Pre-requisite(s): Provisional Admission Provides an introduction to welding technology with an emphasis on basic welding laboratory principles and operating procedures. Topics include: industrial safety and health practices, hand tool and power machine use, measurement, laboratory operating procedures, welding power sources, welding career potentials, and introduction to welding codes and standards.